Carrier Access Access Navigator user manual Send switch provision request, Show isdn database

Provision GR-303 Service

Provision ISDN BRI 4:1 TDM Service to Subscribers

4.Un-assign ISDN BRI channels with the following command: set ds0 <n:ch> isdn none

Example: set ds0 10:10 isdn none

NOTE: In the set ds0 isdn command, the crv <range> modifier can only be used to assign D channel CRVs. The D channels must be assigned in groups of four, but a zero can be used as a place holder.

The B1, B2, and D channels of each ISDN BRI connection must use the same CRV.

5.Set ISDN BRI B1, B2, and D channels and CRVs with the following command: set ds0 <n:ch> isdn <b1b2d> crv <range>

Example:	set ds0 10:1 isdn b1 crv 1
Example:	set ds0 10:2 isdn b2 crv 1
Example:	set ds0 10:3 isdn b1 crv 2
Example:	set ds0 10:4 isdn b2 crv 2
Example:	set ds0 10:24 isdn d crv 1,2,3,4

NOTE: If RDT provisioning is enabled in the switch, the switch can upload the ISDN CRVs and provision the ISDN D channel DS0s, without requiring a switch operator to manually enter this information into the switch database. The Access Navigator will then crossconnect the D channel switch DS0s to the drop DS0s.

6.If RDT provisioning is enabled in the switch, send the switch a request to provision the ISDN CRVs with the following command:

send switch provision request

Verify that switch has provisioned ISDN D channel DS0s:

show isdn database

Skip remaining steps.

Access Navigator - Release 1.8 August 2003 10-27