Carrier Access Access Navigator Status DS1 Performance, Syntax status ds1 n performance

Diagnostics & Troubleshooting

Status DS1 Performance

Item	Description
Remote Device	n/a – not applicable
Management	CA FDL – Used to provision remote Access Bank II or
	establish pass-through management session to Adit 600.
	CA IP – Used for IP DS0 management of
	remote Adit 600.
	CA DS1 <n> – Used for IP DS0 management of remote
	Adit 600.
	In Service – Management link is in service (up)
	Out of Service – Management link is out of service (down).
	(See Set DS1 Remote Device Mgmt on page 18-113.)
Clock Source	Indicates Primary or Secondary if DS1 line receiver is used for
	master clock source

Status DS1 Performance

Displays current performance data for the specified DS1. The Access Navigator accumulates DS1 performance data for the parameters described in RFC 1406 – Definitions of Managed Objects for the DS1 and E1 Interface Types. All performance parameters are accumulated in fifteen minute intervals. The “current” 15 minute interval shows data collected when the command is received, and always represents an elapsed time of less than 15 minutes. At the end of each 15 minute interval, the Access Navigator displays the total as the “previous” 15 minute interval and computes new totals for 1 hour and 1 day by summing previous intervals.

The clear ds1 performance command can be used to reset the performance data for a specific DS1. When this is done, the timer for that DS1 will start at zero hours, minutes, and seconds. (See Clear DS1 Performance on page 15-18.)

The status performance message will include an asterisk (*) to mark error counts that exceed the threshold values set by the Set DS1 Threshold on page 18-115. Exceeding a threshold can cause an automatic alarm message to be sent to the network operations center.

Syntax: status ds1 <n> performance

Field

n

Description

DS1 number, 1 to 32, or a range of numbers such as 2-8.

Example: status ds1 9 performance

Message:

Performance Statistics for DS1 #9		previous
	current			day
	15 min.	15 min.	hour
unavailable seconds:	-------- --------		--------	--------
	0	0	0	0
errored seconds:	1	0	577*	29377*
severely errored seconds:	0	0	0	0
sev. errored frame seconds:	0	0	0	0

15-16 August 2003 Access Navigator - Release 1.8