Carrier Access Access Navigator user manual Ensure Adequate Clearance, Prepare Plywood

Physical Installation

Tools and Materials

Tools and Materials

Obtain the following tools and materials:

•Phillips screw drivers, #2 and #3

•Screws (8 ea.), #8 × 3/4 inch panhead

•Universal mounting kits (2 ea.), PN 710-0153. (Access Navigator includes one kit.)

•Plywood, 3/4 inch thick, 10 × 21 inches minimum size

Ensure Adequate Clearance

Ensure there is adequate clearance around Access Navigator to access cards and connectors, and sufficient space for proper ventilation (see Figure 5-10 on page 5-18).

Prepare Plywood

1.Ensure that plywood is large enough to hold the Access Navigator (see Figure 5-11 on page 5-19). Plywood should extend at least 1 inch beyond brackets.

2.Mark mounting hole locations on plywood to ensure that brackets will mount squarely against plywood (see Figure 5-12 on page 5-20).

Attach Mounting Brackets to Access Navigator

NOTE: Universal mounting kit includes hardware that is not required for wall mount installation.

1.Open bags containing the universal mounting kits and select the following items (see A in Figure

5-13 on page 5-21):

•Mounting brackets (4 ea.), PN 0040303 (stamped on part)

2.Position mounting brackets for wall mounting (see B in Figure 5-13).

3.Remove two mounting screws (6-32 × 3/8 inch, 82º undercut, Phillips) from Access Navigator where each bracket will be attached (see C in Figure 5-13).

4.Attach mounting brackets to each side of Access Navigator using the mounting screws removed in previous step (see C in Figure 5-13). Slide brackets down in screw slots to ensure maximum space beneath Access Navigator for ventilation.

5-16 August 2003 Access Navigator - Release 1.8