Carrier Access Access Navigator user manual Set Alarms, Set Autoexit, Example set alarms major on

CLI Language Reference

CLI Command List

Set Alarms

Purpose: Allows the user to test the Access Navigator alarm functions by manually setting a critical, major, or minor alarm state.

NOTE: Turning alarms on or off will produce alarm messages and log entries stating that the alarm event was manually set or cleared by the user. Manually set alarms are not reported over the GR-303 EOC link to the switch.

Security: Level 2 (operator)

Syntax: set alarms <criticalmajorminor> <onoff>

Field	Description
critical	Select critical alarm
major	Select major alarm
minor	Select minor alarm
on	Activate manual alarm
off	Deactivate manual alarm

Example: set alarms major on

Lights the major alarm LED on the front panel and closes the contacts on the major alarm relay output.

Set Autoexit

Purpose: This command adds a settable timeout that can be enabled or disabled for each supported CLI session. The Access Navigator can have up to three active CLI sessions at the same time, one via RS-232 and two via Telnet. When enabled, the CLI session will automatically expire if there is no user activity during the specified time period. This feature enhances system security by ensuring that the session will be closed if the user forgets to log off. To disable the feature and prevent a timeout from occurring, enter zero as the time.

Security: Level 2 (operator)

Syntax: set autoexit <minutes>

Field	Description
minutes	Timeout period, 1 to 255 minutes. Enter 0 to disable timeout.

Example: set autoexit 60

Access Navigator - Release 1.8 August 2003 18-95