Carrier Access Access Navigator user manual Provision Switch DS1s to Interface Group

Provision GR-303 Service

Provision “Switch” DS1s to Interface Group

Provision “Switch” DS1s to Interface Group

1.Show switch DS1 settings with the following command: show ds1 <n>

Example: show ds1 25

The show command will produce a message showing the DS1 settings. For example, the message for DS1 number 25 might look similar to the following:

Settings for DS1 25:	CA DS1# 25
Circuit ID:
Up/Down:	DOWN
Framing:	ESF
Line Coding:	B8ZS
Type:	SWITCH
Clock Source:	NORMAL
Line Build Out:	DSX-1 EQUALIZATION FOR 0-133 ft.
Loop Code Detection:	OFF
Loop Back:	OFF
Line Termination ID:	1(for switch DS1s only)
FDL Type:	NONE
Send Code:	NONE	15 min.	1 hour	1 day
Performance Thresholds:
unavailable seconds:	--------		-------	------
		0	0	0
severely errored seconds:		0	0	0
errored seconds:		0	0	0
sev. errored frame seconds:		0	0	0
degraded minutes:		0	0	0
linecode violations:		0	0	0

NOTE: In the above message, loop back is a test function that is turned off during normal service. Line Termination IDs are used only by GR-303 switch DS1s.

2.If switch DS1 settings are correct, skip remaining steps.

3.Set DS1 type to “switch” with the following command: set ds1 <n> type switch

Example: set ds1 25 type switch

4.Set switch DS1 frame type to ESF with the following command: set ds1 <n> framing esf

Example: set ds1 25 framing esf

Access Navigator - Release 1.8 August 2003 10-15