Carrier Access Access Navigator user manual 18-160

CLI Language Reference

CLI Command List

Description:

Item	Description
Receive	Traffic – normal operation.
	(The CLI also shows alarm conditions.)
Transmit	Traffic – normal operation.
	(The CLI also shows alarm conditions.)
Loop	None – normal operation.Line – line loopback.
	Payload – payload loopback.
State	In use as DROP – Subscriber “drop” DS1.
	In use as GROOM – DCS “groom” DS1.
	In Service – GR-303 “switch” DS1.
	User set Out of Service – User set DS1 down.
	Card Not Installed – Empty card slot
	(The CLI also displays alarm messages such as RAI.)
FDL Type	None – No detection or response (only option for switch DS1s).
	SLC96 – Required for Shelf A of SLC-96/TR-08 group.
	T1403 – Detects and responds to ANSI T1.403 codes.
	(See Set DS1 FDL on page 18-106.)
Remote Device	None – no management
Mgmt Type	CA FDL – Used to provision remote Access Bank II or
	establish pass-through management session to Adit 600.
	CA IP <ipaddress> – Used for IP DS0 management of
	remote Adit 600.
	CA DS1 <n> – Used for IP DS0 management of remote
	Adit 600.
	(See Set DS1 Remote Device Mgmt on page 18-113.)
Remote Device Mgmt	Up or Down – Shown only if Remote Device Mgmt Type is CA
Status	IP or CA FDL.

18-160 August 2003 Access Navigator - Release 1.8