Carrier Access Access Navigator user manual Remote Adit IP DS0 Provisioning Quick Guide

Provision Remote Adit 600 via IP DS0

Remote Adit IP DS0 Provisioning Quick Guide

Remote Adit IP DS0 Provisioning Quick Guide

NOTE: The following commands assume that the remote Adit is set to the factory defaults.

Adit CLI Commands	Descriptions
set local off	Sets Adit to be configured through
	CLI.
set a:2 down	Sets T1-2 out of service.
disconnect a	Disconnects all connections to slot a
	(controller).
set a:1:24 type data	Sets all DS0s on T1-1 to data
	signalling type.
set ipds0 assign a:1:24	Assigns DS0 24 as the IP management
	channel.
set ipds0 ip address <address> <mask>	Sets the DS0 management channel IP
	address (Adit WAN address).
set ipds0 up	Set DS0 management channel in
	service.
show connect a:1	Displays connections to T1-1 of the
	controller.
show ipds0	Displays configuration of the DS0
	management channel.
status ipds0	Displays status (up/down) of the DS0
	management channel.

Test the DS0 management channel as follows:

1.PING Adit1 IP address from the Adit Router.

2.PING Adit1 IP address from the Access Navigator.

3.PING Adit1 IP address from the management PC.

4.Telnet to Adit1 IP address from the PC to the remote Adit.

Access Navigator - Release 1.8 August 2003 13-7