Carrier Access Access Navigator Isdn BRI 41 TDM channels, Connect Isdn D channel to Switch

Provision GR-303 Service

Obtain Provisioning Information

CLI Commands	Descriptions
set ds0 <n:ch> isdn <b1b2d> crv	ISDN BRI 4:1 TDM channels.
<range>
set ds0 <n:ch> crv <range>	Assign Drop DS0s to CRVs in sequential
set ds0 <n:ch> crv <range> slc96	order or in odd-even (slc96) order.
connect <n:ch> <n:ch>	Connect ISDN D channel to Switch.
set ds0 <n:ch> up	Set DS0s in service.
set ds1 <n> up	Set DS1s in service.

Obtain Provisioning Information

1.Obtain office records for installation site.

2.Obtain circuit orders for GR-303 service turn up.

Verify System Equipment Configuration

CAUTION! VERIFY CURRENT CONFIGURATION AND SERVICE STATUS WITH OFFICE RECORDS BEFORE ADDING, DELETING, OR CHANGING CIRCUITS.

NOTE: The factory default sets all DS1s and DS0s in-service (up). To prevent inadvertent service disruptions, it is good practice to set circuits out of service (down) when not in use or not provisioned in the switch. Set the type of unused DS0 channels to match the DS0 type configured on the device at the other end of the DS1. If the DS1 is not terminated, set the type to data.

1.Start management session (see Start Management Session on page 7-1).

2.Show system equipment configuration with the following command: status equipment

A message similar to the following will appear, showing the equipment card slots, service status, and Controller software version.

Equipment	Status	Version
---------	------	-------
Controller A	Active	01.70 GR-303 Option
Controller B	Standby	01.70 GR-303 Option
DS1 Card 1	Installed	1
DS1 Card 2	Installed	1
DS1 Card 3	Installed	1
DS1 Card 4	Installed	1
DS1 Card 5	Installed	1

10-10 August 2003 Access Navigator - Release 1.8