Carrier Access Access Navigator user manual Interface

Provision Remote Adit 600 via FDL

Verify Equipment Configuration

NOTE: Commands containing ds0 <n:ch> require the operator to enter both the DS1 and DS0 channel number or channel range. The DS1 and DS0 numbers are entered with a colon separating the numbers. For example, the channel list for DS1 #4 and DS0 channel #8 would be entered as ds0 4:8. The channel list may also contain a range of DS0 channels. For example, DS1 #6 and DS0 channels #1 through #12 would be entered as ds0 6:1-12. A colon follows the DS1 number, and the beginning and ending DS0 channels are separated by a hyphen.

9.Display current DS0 status with the following command, where <n:ch> is the DS0 or range of DS0s in the DS1 to be turned up:

status ds0 <n:ch>

Example: status ds0 10:1-4

The status command will display the status for each DS0 specified. For example, the message for DS1 #10, DS0 channels 1 to 4, and DS1 #32, DS0 channels 1 to 4, would look similar to the following:

Interface		Status
---------		------
DS1 10 Channel 1		In Service
DS1 10 Channel 2		In Service
DS1 10 Channel 3		In Service
DS1 10 Channel 4		In Service
DS1 32	Channel 1	Card Not Installed
DS1 32	Channel 2	Card Not Installed
DS1 32	Channel 3	Card Not Installed
DS1 32	Channel 4	Card Not Installed

10.Verify status of DS0 circuits on DS1 lines to be turned up by comparing DS0 status with office records. If there is a discrepancy, follow standard practices to resolve problem.

Access Navigator - Release 1.8 August 2003 12-9