Carrier Access Access Navigator Test Remote Circuits, Call Status FX and Spots To Loop or

Provision Remote Access Bank II

Test Remote Circuits

Test Remote Circuits

NOTE: The Access Navigator can be pre-provisioned so that it will be ready to provide services when facilities become available. Therefore, it may be necessary to skip over the circuit testing steps in this procedure.

NOTE: The Access Navigator supports the following T1.403 loop tests:

•Responds to ESF bit patterned loop requests (when loopdetect is on)

•Generates ESF bit patterned loop requests

•Generates SF CSU inband loopcodes

NOTE: The Access Navigator provides line and payload loopback commands for troubleshooting line problems. See Diagnostics & Troubleshooting on page 15-1.

1.Follow standard practices to test subscriber drop DS1 circuits.

2.Follow standard practices to test DS0 connections, analog channels, and remote interfaces.

NOTE: Access Bank II Indicators – The following table shows analog card channel status indications for loop start and ground start subscriber connections. The default DIP switch settings provide automatic loop start and ground start translation for each channel. Other DIP switch settings provide various E&M signaling options, which apply to the entire card.

Call Status	FX and SPOTS	FX and SPOTS	E&M to Loop or
	Loop Start (SPR)	Ground Start (UVG)	Ground Start
Idle	Green	Off	Off
Incoming Seizure	Green	Green	Green
Ringing	Green	Green	Green
Outgoing Seizure	Yellow	Red	Red
Completed Call	Yellow	Yellow	Yellow
Unsupported	Red Flashing	Red Flashing	Red Flashing
signaling option
selected

11-30 August 2003 Access Navigator - Release 1.8