Carrier Access Access Navigator user manual Provision Drop DS1s to Remote Adit

Provision Remote Adit 600 via FDL

Provision Drop DS1s to Remote Adit 600

Provision Drop DS1s to Remote Adit 600

1.Show drop DS1 settings with the following command: show ds1 <n>

Example: show ds1 10

The show command will produce a message showing the DS1 settings. For example, the message for DS1 number 1 might look similar to the following:

Settings for DS1 1:	CA DS1# 01
Circuit ID:
Up/Down:	UP
Framing:	ESF
Line Coding:	B8ZS
Type:	DROP
Clock Source:	NORMAL
Line Build Out:	DSX-1 EQUALIZATION FOR 0-133 ft.
Loop Code Detection:	OFF
Loop Back:	OFF	(for switch DS1s only)
Line Termination ID:	0
Remote Device MGMT:	CA FDL
FDL Type:	None
Send Code:	OFF	15 min.	1 hour	1 day
Performance Thresholds:
unavailable seconds:	--------		--------	--------
		0	0	0
severely errored seconds:		0	0	0
errored seconds:		0	0	0
sev. errored frame seconds:		0	0	0
degraded minutes:		0	0	0
linecode violations:		0	0	0

NOTE: Access Navigator Release 1.7 provides new remote management commands. For Carrier Access FDL management, the Remote Device Management type must be set to CA FDL and the DS1 FDL type must be set to None.

2.If drop DS1 settings are correct, skip remaining steps.

3.Set DS1 out of service with the following command: set ds1 <n> down

Example:	set ds1	1 down
Example:	set ds1	10-15 down

12-10 August 2003 Access Navigator - Release 1.8