Carrier Access Access Navigator FDL Management Configuration, On-Net Customer Location Premises

Provision Remote Adit 600 via FDL

FDL Management Configuration

After configuring the FDL management connection, the user can remotely provision the Adit 600 by logging onto the Access Navigator, starting a remote management session, and sending Adit 600 CLI commands over the FDL channel.

FDL Management Configuration

NOTE: T1 Type 1 facilities are recommended for reliable remote management. Type 2 facilities – in which the T1 is transported across other carrier networks – may not be reliable because the FDL channel can be used or disabled by the other carriers.

FDL management requires T1 facilities with ESF framing to carry management and provisioning commands over the DS1’s Facility Data Link. The Access Navigator must have software version 1.5 or higher and the DS1 link between the Access Navigator and the remote Adit 600 terminal must be provisioned for Carrier Access FDL management. Only one FDL management link should be made to the Controller card of each remote Adit 600.

Network

Operations

Center

CLI/Telnet

Management

Console

On-Net		Customer
Location		Premises
	FDL

Adit 600

ACCESS
NAVIGATOR
Access	DS1s	Adit 600
Navigator

Figure 12-2 Carrier Access FDL Management Configuration

Access Navigator - Release 1.8 August 2003 12-3