Carrier Access Access Navigator user manual Status TMC History, Syntax status tmc allinterval

Diagnostics & Troubleshooting

Status TMC History

Status TMC History

Displays TMC call for the last 48 hours (all) or a range of hours (interval). The resulting messages are similar to the following. (For current status information, see Status TMC on page 15-25.)

Use clear commands to reset the Blocked Call Count, Peak Call Count, and Permanent Call Count

Syntax: status tmc <allinterval>

Field

all

interval

Description

Shows all TMC statistics for the last 48 hourly intervals.

Shows statistics for a time interval, such as 8-12 hours.

Example: status tmc all

Example: status tmc 8-12

Message:

TMC Calls	History	time	permn.	blocked	peak	switch ports/
int#	date
-----	----------	--------	calls	calls	calls	percent used
			--------	--------	--------	-------------
8	04/17/2000	11:48:47	0	0	37	140	/ 26
9	04/17/2000	10:48:47	0	0	85	140	/ 61
10	04/17/2000	09:48:47	0	17	140	140	/ 100
11	04/17/2000	08:48:47	0	0	118	140	/ 84
12	no data for	this interval.

Description:

Item	Description
int#	One-hour intervals, numbered from 1 to 48.
Date	month/day/year
Time	24-hour clock in hours:minutes:seconds
Permanent Calls	Number of calls currently set in a permanent off-hook state. This
	state will be cleared when an on-hook is observed for more than
	400 milliseconds. (Permanent calls can also be cleared as
	described in Clear Permanent Call Count on page 15-28and
	“Set CRV Idle” on page 28.)
Blocked Calls	Number of calls blocked by Access Navigator or switch. (To
	clear, see “Clear Blocked Call Count” on page 28.) Switch may
	also refuse call if line configuration is not correct. Blocking can
	occur because:
	• Switch side DS0s are not available for call request.
	• Switch is not configured for call request from CRV.

Access Navigator - Release 1.8 August 2003 15-27