Carrier Access Access Navigator user manual Ca Fdl, Status remote nall

Provision Remote Adit 600 via FDL

Verify Equipment Configuration

NOTE: Commands containing ds1 <n> require the operator to enter a DS1 number or range of numbers. For example, DS1 #6 is entered as ds1 6. If a DS1 range is specified, the command operations will be applied to all DS1s in the range. To enter a range of DS1s, type the starting and ending numbers, separated by a hyphen. For example, DS1s #1 through #8 can be specified by typing ds1 1-8.

6.Show current DS1 status with the following command, where <n> is the DS1 or range of DS1s to be turned up:

status ds1 <n>

Example: status ds1 1

This command will produce a message listing the status of the specified DS1 or range of DS1s. For example, the message for DS1 #9 and #32 might look similar to the following. Note that the message for DS1 #9 shows the DS1 is in service, while the message for DS1 #32 indicates there is no Quad Framer circuit card installed.

Status for	DS1 9:	Traffic
Receive:
Transmit:		Traffic
Loop:		None
State:		In use as DROP
FDL Type:		None
Remote	Device Mgmt Type:	CA FDL
Status for	DS1 32:	Traffic
Receive:
Transmit:		Traffic
Loop:		None
State:		Card Not Installed
FDL Type:		None
Remote	Device Mgmt Type:	None

7.Verify status of DS1 lines to be turned up by comparing DS1 status with office records. If there is a discrepancy, follow standard practices to resolve problem.

8.Verify current status of any remote devices with the following command, where <n> is the DS1 or range of DS1s to be turned up:

status remote <nall>

Example: status remote 1

This command will produce a message listing the remote terminals at the far end of the DS1s.

DS1	Terminal	ID	Status
---	--------------------	----------------------	--------------
1	CA Adit 600	Remote Device #1	In Service as CA FDL

12-8 August 2003 Access Navigator - Release 1.8