Carrier Access Access Navigator user manual Show IP, Show Isdn CRV

CLI Language Reference

CLI Command List

Show IP

Purpose: The Ethernet port on the Access Navigator provides an Internet Protocol (IP) interface. Currently, the show ip and status ip commands produce the same message, listing the IP address and subnet mask, and the gateway address.

Security: Level 3 (monitor)

Syntax: show ip

Message:

IP Address and Mask:			192.168.3.158 255.255.255.0
IP Address of the Gateway:			192.168.3.202
Description:
	Field	Description
	IP Address	Each Access Navigator on the same Ethernet network must have
		a unique static Internet Protocol (IP) address. IP addresses have
		the format xxx.xxx.xxx.xxx, where each xxx is a decimal
		number between 0 and 255. For example, 192.168.0.123 is a
		valid IP address. Note that the address contains only three
		periods, one between each of the four numbers. If the Ethernet
		interface is not used, type none for the IP address.
	IP Mask	The Access Navigator uses a subnet mask to identify the
		permissible range of addresses for each IP address. Large
		networks are usually divided into smaller subnetworks, each with
		an assigned range of IP addresses. Subnet masks have the format
		xxx.xxx.xxx.xxx, where each xxx is a decimal number
		between 0 and 255. Subnet masks usually start with one or more
		groups of 255. Typical examples include 255.255.0.0 and
		255.255.255.0. If a subnet mask is not used, the field will be
		blank.
	IP Address of Gateway	Gateway addresses have the format xxx.xxx.xxx.xxx,
		where each xxx is a decimal number between 0 and 255. If a
		gateway address is not used, the value is none.

Show ISDN CRV

Purpose: Displays a message listing the status of the specified ISDN BRI channels. To display the ISDN BRI channels, you must enter a CRV or range of CRVs.

NOTE: The show ds0 command lists ISDN and CRV information by channel number rather than CRV. See Show DS0 on page 18-139.

Security: Level 3 (monitor)

18-148 August 2003 Access Navigator - Release 1.8