Carrier Access Access Navigator user manual Show DS1, Syntax show ds1 n, Example show ds1

CLI Language Reference

CLI Command List

Settings for DS1 13, Channel 4:

Type:GR303

Up/Down:UP

CRV:38

PPHONE:Enabled

ISDN:None

NOTE: In the above message, the channel type can be GR303 (voice or ISDN BRI), or private crossconnects using VOICE or DATA. P-Phone settings only appear in the Access Navigator / GR-303 Host with P-Phone.

Description:

Item	Description
Type	VOICE, DATA, GR303 (voice).
	(Both ISDN and P-Phone service require GR303 type.)
Signaling	LOOP START, GROUND START, E&M, Direct Inward Dial.
	(No signaling is used for data types or ISDN BRI. E&M is not
	valid for GR-303.)
Up/Down	UP (in service), DOWN (out of service).
CRV	Call Reference Value, 1 to 768, or "No CRV assigned"
ISDN	ISDN BRI channel (if any), B1, B2, or D
PPHONE	ENABLED, DISABLED.

Show DS1

Purpose: Displays the DS1 settings and current service status, including thresholds for detected near-end line errors. This command will show the current settings in a message similar to the following. The settings can be changed with the various set ds1 commands. (To quickly display an abbreviated list of all 32 DS1s, use the show ds1 all command.)

Security: Level 3 (monitor)

Syntax: show ds1 <n>

Field	Description
n	DS1 number, 1 to 32, or a range of numbers such as 2-8.

Example: show ds1 12

Example: show ds1 1-8

18-140 August 2003 Access Navigator - Release 1.8