Carrier Access Access Navigator user manual Remote IP DS0 Provisioning Overview

Provision Remote Adit 600 via IP DS0

Remote IP DS0 Provisioning Overview

Remote IP DS0 Provisioning Overview

This procedure covers remote management and provisioning of Carrier Access’ Adit® 600 TDM Customer Service Terminals. The Adit 600 TDM provides six service card slots that support up to 18 T1s (DS1s) per unit, up to 48 voice channels, or any combination of voice and data services.

The Access Navigator / GR-303 + Data Host and GR-303 Host with P-Phone can both serve as a host for remote Adit 600 terminals, providing GR-303 voice concentration and data grooming.

There are two management configurations:

￿IP DS0 Management – sends IP management commands over a DS0 channel in the drop DS1.

￿FDL Management – sends CLI commands over the DS1’s ESF Facility Data Link (FDL). This FDL management configuration does not support P-Phone service from the remote Adit 600. See Provision Remote Adit 600 via FDL on page 12-1.

After configuring the IP DS0 management connection, the user can remotely provision the Adit 600 by sending NetworkValet™ EMS IP commands or Adit CLI/Telnet commands over the IP DS0 management channel.

Network		On-Net		Customer			Customer
Operations
		Location	Wiring Closet				Premises
Center
CLI/Telnet					Voice Interfaces
	SNMP
	IP	Access			P-Phone			P-Phones
	TCP/IP	Navigator
Magement	Network			Adit 600			Key System
					FXS/FXO
Console								Fax
		DS1s
	Voice			CACTUS.lite
					Data Interfaces
	Switch
					VoIP	PBX		Stations
					T1 Drop
	Data
	Switch	Local			10/100BaseT
		Management					Modem
		CLI/RS-232			RS232

DDS

ISDN BRI

T1 Drop Router

V.35Ethernet

Figure 13-1 Adit 600 Voice and Data Services with IPD S0 Management

13-2 August 2003 Access Navigator - Release 1.8