Carrier Access Access Navigator user manual Set DS0 Type, Signaling Used in Common Applications

CLI Language Reference

CLI Command List

Switch

Line Switch

Side DS1

GR-303

		Access Bank
		or Adit 600
	Drop		LS	Phone
Access	DS1	T1
Navigator
	DID, EM,		GS	PBX
	GS, LS

Access Bank

or Adit 600

Switch

Line Groom

Side DS1

GS, LS

	Drop	T1
Access	DS1
Navigator	GS, LS

LS Phone

GS PBX

Access Bank

or Adit 600

Trunk

Side

Switch

Groom

DS1

DID, EM

Access	Drop	T1
	DS1
Navigator
	DID, EM

LS Phone

GS PBX

Signaling Type: DID	Direct Inward Dial	Configure terminals
EM	E&M	to perform desired
GS	Ground Start	signaling conversions
LS	Loop Start

Figure 18-27. Signaling Used in Common Applications

Set DS0 Type

NOTE: If the DS0 is part of a fractional interface used to provision a remote Access Bank II, the DS0 type can not be changed without first deleting the fractional interface.

Purpose: Specifies the DS0 channel type on “Drop” DS1s. There are three types: Voice, Data, and GR-303. The distinction is important because Voice and GR-303 channels use robbed-bit signaling, except when GR-303 carries ISDN BRI traffic, while Data is always a clear channel.

Security: Level 2 (operator)

Access Navigator - Release 1.8 August 2003 18-105