Carrier Access Access Navigator user manual Management Requirements, Start Management Session

Start Management Session

Management Requirements

Management Requirements

NOTE: Password Security – No user names or passwords are required for installation and initial turn up until user and password security is activated.

Provisioning requires RS-232 or Ethernet connections to the Access Navigator. The Access Navigator operating system provides a Command Line Interface (CLI), which uses simple text based commands and messages. CLI is used with both RS-232 terminal programs and Telnet.

Remote	IP, SNMP,
Management	Telnet CLI
	RS-232 CLI
Network
Operations		Local
Center
	Management

Computer or

Craft Terminal

Hub or

Network

Modem or

Direct

IP, SNMP, Telnet CLI

RS-232 CLI

Ethernet

RS-232

Access

Navigator

NOTE: RS-232 and Ethernet Connections are normally made during installation (seeRS-232 Management Connection on page 6-17and Ethernet Management Connection on page 6-22).

￿RS-232 CLI Management requires an RS-232 connection to the Access Navigator.

￿Telnet CLI Management requires an Ethernet connection to the Access Navigator. The Ethernet function can only be turned up through the RS-232 management interface.

￿SNMP Management requires an Ethernet connection to the Access Navigator. The SNMP function can only be turned up through the RS-232 or Telnet management interface.

￿Valet™ and NetworkValet™ EMS require an Ethernet connection to the Access Navigator. Valet and NetworkValet EMS are Carrier Access element management software products that provide an easy-to-use graphical user interface.

7-2 August 2003 Access Navigator - Release 1.8