Carrier Access Access Navigator user manual Dress Cables and Wires

Electrical Installation

Dress Cables and Wires

Dress Cables and Wires

Installation Summary

￿Tools and Materials ... 6-38

￿Dress Cables and Wires ... 6-38

Tools and Materials

Obtain the following tools and materials:

•Pliers, needle nose

•Cutters, diagonal

•Wire ties (3 ea.), part of Accessory Kit, PN 003-0247

Dress Cables and Wires

Dress cables and wires as follows.

•Follow standard practice.

•If desired, use wire tie anchors on rear panel (see Figure 6-25)to secure wires.

•Ferrite bead RF suppressors may be moved slightly to allow for securing wire ties.

•When mounted horizontally, the ground wire and DSX-1 cables are normally dressed toward left side of rack and all other cables and wires are dressed toward right side, as viewed from connector panel (Figure 6-25).

•Ensure that no bare wires are exposed after dressing.

Wire Tie Anchor			Wire Tie Anchor
	DSX-1 Cable	DSX-1 Cable

Ground	Timing	Alarm	-48V	Alarm	-48V Ethernet RS-232
Wire	In	Out	B	In	A	CLI

Figure 6-25. Location of Rear Panel Wire Tie Anchors and Connectors

6-38 August 2003 Access Navigator - Release 1.8