Carrier Access Access Navigator user manual Test Groom DS1 Circuits

Provision DCS Service

Test Groom DS1 Circuits

Test Groom DS1 Circuits

NOTE: The Access Navigator supports the following T1.403 loop tests:

•Responds to ESF bit patterned loop requests (when loopdetect is on)

•Generates ESF bit patterned loop requests

•Generates SF CSU inband loopcodes

Follow standard practices to test groom DS1 circuits.

Provision “Drop” DS1 Circuits to Subscribers

1.Show drop DS1 settings with the following command: show ds1 <n>

Example: show ds1 20

The show command will produce a message showing the DS1 settings. For example, the message for DS1 number 20 might look similar to the following:

Settings for DS1 10:	CA DS1# 20
Circuit ID:
Up/Down:	DOWN
Framing:	ESF
Line Coding:	B8ZS
Type:	DROP
Clock Source:	NORMAL
Line Build Out:	DSX-1 EQUALIZATION FOR 0-133 ft.
Loop Code Detection:	OFF
Loop Back:	OFF
Line Termination ID:	0 (for switch DS1s only)
FDL Type:	CAC
Send Code:	None	15 min.	1 hour	1 day
Performance Thresholds:
unavailable seconds:		--------	-------	------
		0	0	0
severely errored seconds:		0	0	0
errored seconds:		0	0	0
sev. errored frame seconds:		0	0	0
degraded minutes:		0	0	0
linecode violations:		0	0	0

NOTE: In the above message loop back test function is turned off and the send code set to none during normal service. Line Termination IDs are used only for GR-303 switch DS1s.

2. If drop DS1 settings are correct, skip remaining steps.

9-14 August 2003 Access Navigator - Release 1.8