Provision Remote Access Bank II

Create Fractional Interfaces (if required)

Create Fractional Interfaces (if required)

NOTE: A fractional interface must be created for each Access Bank II remote port (RS- 232, T1 Drop, or V.35) to be turned up. If these interfaces are not required, go to Download Configuration to Remote Access Bank II on page 11-28.

1.Verify fractional interface settings with the following command: show interface all

Example: show interface all

Example: show interface acmet1

The show command will produce a message showing the interface settings. For example, the messages for the AcmeT1 and AcmeV35 interfaces might look similar to the following:

Settings for Interface AcmeT1

9:13-18

Interface Channels:

Interface Index:

1

Remote Device Type:

T1Drop

Interface Type:

Voice

Settings for Interface AcmeV35

Interface Channels:

9:19-24

Interface Index:

2

Remote Device Type:

V35

Interface Type:

Data

2.If interface settings are correct, skip remaining steps.

3.If any interface DS0s must be changed, remove the old interface with the following command: delete interface <"name">

Example: remove interface "AcmeT1drop"

4.Add a new fractional interface for voice, data, or GR-303 service for the desired DS0s with the following command:

add interface <"name"> <n:ch> <voicedatagr303>

Example:

add interface "AcmeT1" 9:13-18 voice

The interface name may contain up to 18 characters and must be enclosed in quote marks.

Access Navigator - Release 1.8

August 2003

11-21

Page 268 Page 270
Page 269
Image 269
Carrier Access Access Navigator user manual Create Fractional Interfaces if required
Page 268 Page 270
Top Page Image Contents