Carrier Access Access Navigator user manual Connect Remote Interface, Drop Groom Switch

CLI Language Reference

CLI Command List

Table 18-1 Valid Crossconnect Assignments

DS1			Drop			Groom			Switch
Type
	DS0	Voice	Data	GR-303	Voice	Data	GR-303	Voice	Data	GR-303
	Type
Drop	Voice	Valid			Valid
	Data		Valid			Valid
	GR-303									Note*
Groom	Voice	Valid			Valid
	Data		Valid			Valid
	GR-303
Switch	Voice
	Data
	GR-303			Note*

*Note: Only ISDN D channels can be statically crossconnected between a switch and drop DS0s.

Connect Remote Interface

Purpose: Connects the DS0s in a fractional interface to a remote Access Bank II voice or data interface (FX, RS-232, T1 Drop, or V.35). This command uses only the name of the fractional interface, which defines the DS0s being connected. Use the show interface command to display connections (see “Show Interface” on page 18-146).

NOTE: Crossconnections between DS0s in the Access Navigator (connect ds0) must be made before adding a fractional interface (add interface) to connect DS0s in the remote Access Bank II (connect interface). This is necessary to prevent connections between incompatible DS0s, such as voice and data.

The Access Bank II includes crossconnect switches for connecting DS0s between the DS1 drop and the various Access Bank II remote interface ports. These connections are made by using CLI commands to set up crossconnects between a fractional interface and a remote interface.

When provisioning a remote Access Bank II, you must first use the add interface command to create a fractional interface, specifying the interface name and the DS0s to be used on the Access Navigator’s drop DS1 (see Add Interface on page 18-23).

Then use the connect interface command to connect the fractional interface DS0s to the desired Access Bank II remote interface port. If the DS0s are currently

Access Navigator - Release 1.8 August 2003 18-31