Carrier Access Access Navigator user manual Status Remote, Syntax status remote nall

CLI Language Reference

CLI Command List

Item	Description
Status	The following states may appear:
	Not Assigned
	Not Assigned to ISDN
	Not Available
	In Service
	User set Out of Service
	Switch set Out of Service
	Under user test control
	In Loopback
	Card not Installed
	Facility failure
	DS0 is not a drop side GR303 channel
	DS1 Out of Service
Call Status	The following states may occur when CRV is In Service:
	Active – Call in progress (off hook)
	Idle – Line available (on hook)
	Permanent – Line not available because of permanent off-hook
	state
	n.a. – not applicable

Status Remote

Purpose: Displays a message listing the remote terminals at the far end of the DS1s. The command syntax lets the operator request a specific DS1, range of DS1s, or all DS1s. The Access Navigator can identify Carrier Access remote terminals, such as the Access Bank II and Adit 600, over the DS1 FDL channel.

Security: Level 3 (monitor)

Syntax: status remote <nall>

Field

n

all

Description

DS1 number, 1 to 32, or a range of numbers such as 2-8.

Display all DS1 remote interfaces.

Example: status remote all

Example: status remote 1

Example: status remote 1-7

18-172 August 2003 Access Navigator - Release 1.8