Carrier Access Access Navigator user manual Set DS0 P-Phone

CLI Language Reference

CLI Command List

Set DS0 P-Phone

Purpose: Assigns DS0 channels for P-Phone service. The set ds0 pphone none command is used to remove the P-Phone assignment from a DS0.

NOTE: This command only applies to P-Phone (EBS) channels from remote Adit 600 terminals using Carrier Access IP (CAIP) remote management (see Set DS1 Remote Device Mgmt on page 18-113.) When connected to a Nortel DMS switch, each Access Navigator can support up to 384 P-Phone channels from up to 14 remote Adit 600 terminals.

Security: Level 2 (operator)

Syntax: set ds0 <n:ch> pphone

Syntax: set ds0 <n:ch> pphone none

Field	Description
n	DS1 number, 1 to 32.
ch	DS0 number, 1 to 24, or a range of numbers such as 5-8.
pphone	Set DS0 to carry P-Phone service.
none	Removes P-Phone assignment.

Example: set ds0 10:1 pphone

Example: set ds0 10:2 pphone none

Example: set ds0 12:9-16 pphone

18-102 August 2003 Access Navigator - Release 1.8