Carrier Access Access Navigator user manual Status DS1 All, Syntax status ds1 all

Diagnostics & Troubleshooting

Status DS1 All

Description:

Item	Description
Receive	Traffic – normal operation.
	(The CLI also shows alarm conditions.)
Transmit	Traffic – normal operation.
	(The CLI also shows alarm conditions.)
Loop	None – normal operation.Line – line loopback.
	Payload – payload loopback.
State	In use as DROP – Subscriber “drop” DS1.
	In use as GROOM – DCS “groom” DS1.
	In Service – GR-303 “switch” DS1.
	User set Out of Service – User set DS1 down.
	Card Not Installed – Empty card slot
	(The CLI also displays alarm messages such as RAI.)
FDL Type	None – No detection or response (only option for switch DS1s).
	SLC96 – Required for Shelf A of SLC-96/TR-08 group.
	T1403 – Detects and responds to ANSI T1.403 codes.
	(See Set DS1 FDL on page 18-106.)
Remote Device	None – no management
Mgmt Type	CA FDL – Used to provision remote Access Bank II or
	establish pass-through management session to Adit 600.
	CA IP <ipaddress> – Used for IP DS0 management of
	remote Adit 600.
	CA DS1 <n> – Used for IP DS0 management of remote
	Adit 600.
	(See Set DS1 Remote Device Mgmt on page 18-113.)
Remote Device Mgmt	Up or Down – Shown only if Remote Device Mgmt Type is CA
Status	IP or CA FDL.

Status DS1 All

Displays an abbreviated list showing the status for all 32 DS1 circuits. It produces a message similar to the following, showing the DS1 number, current status, and some common parameters of interest in trouble-shooting. (To obtain a detailed list for a specific DS1 or range of DS1s, use the status ds1 <n> command.)

Syntax: status ds1 all

15-14 August 2003 Access Navigator - Release 1.8