Carrier Access Access Navigator user manual Set DS1 Clock, Set DS1 FDL

CLI Language Reference

CLI Command List

Syntax: set ds0 <n:ch> type <datavoicegr303>

Field	Description
n	DS1 number, 1 to 32.
ch	DS0 number, 1 to 24, or a range of numbers such as 5-8.
data	Set DS0 to carry DCS data traffic.
voice	Set DS0 to carry DCS voice traffic.
gr303	Enable DS0 to carry GR-303 voice traffic. (ISDN BRI 4:1 TDM
	mode circuits are automatically assigned as gr303 type.)

Example: set ds0 2:3 type data

Example: set ds0 2:12 type voice

Example: set ds0 13:1-16 type gr303

Set DS1 Clock

Purpose:	Sets the transmit clock source for the specified DS1 interface.
Security:	Level 2 (operator)
Syntax:	set ds1 <n> clock <normalloop>

Field

n

normal

loop

Description

DS1 number, 1 to 32, or a range of numbers such as 2-8.

Set to master transmit clock source.

Set clocking for this DS1 to clock recovered by DS1 receiver. (Should not be used during normal operation.)

Example: set ds1 9 clock normal

Example: set ds1 1-12 clock normal

Example: set ds1 9 clock loop

Set DS1 FDL

Purpose: Selects the FDL protocol used on drop DS1s. Switch and groom DS1s do not use FDL. The Facility Data Link (FDL) channel is a 4 Kbps out-of-band communications link provided by the DS1 Extended Superframe (ESF) format.

NOTE: The factory default setting is “none”. This also turns off out-of-band loopback code detection and transmission over the FDL channel.

18-106 August 2003 Access Navigator - Release 1.8