Carrier Access Access Navigator user manual Provision Drop DS0s

Provision Remote Adit 600 via FDL

Provision Drop DS0s

Provision Drop DS0s

NOTE: Commands such as ds0 <n:ch> require the operator to enter both the DS1 and DS0 channel number or channel range. The DS1 and DS0 numbers are entered with a colon separating the numbers. For example, the channel list for DS1 #4 and DS0 channel #8 would be entered as ds0 4:8. The channel list may also contain a range of DS0 channels. For example, DS1 #6 and DS0 channels #1 through #12 would be entered as ds0 6:1-12. A colon follows the DS1 number, and the beginning and ending DS0 channels are separated by a hyphen.

1.Show current DS0 settings with the following command: show ds0 <n:ch>

Example: show ds0 13:1-4

The show command will produce a status message for each DS1 specified. For example, the message for DS1 number 13, DS0 channels 1 to 4 would look similar to the following:

Settings for DS1 13, Channel 1:

Type:	VOICE
Signaling:	LOOP START (FXS)
Up/Down:	UP
CRV:	113
ISDN:	none
Settings for DS1 13, Channel 2:
Type:	VOICE
Signaling:	LOOP START (FXS)
Up/Down:	UP
CRV:	114 (assigned but not available)
ISDN:	none

Settings for DS1 13, Channel 3:

Type:DATA

Signaling: NONE

Up/Down: UP

CRV:115

ISDN:B1

Settings for DS1 13, Channel 4:

Type:	DATA
Signaling:	NONE
Up/Down:	UP
CRV:	115 (assigned but not available)
ISDN:	none

2. If drop DS0 settings are correct, skip remaining steps.

Access Navigator - Release 1.8 August 2003 12-13