Carrier Access Access Navigator user manual Set User and Password Security, Add user name

Provision Access Navigator

Set User and Password Security

Set User and Password Security

NOTE: Level 1 users (managers) have access to all commands. Level 2 users have access to all commands except add/delete/set user, but they can change their own password. Level 3 users can only display system status and reports, and they can change their own password.

1.Show current user settings with the following command: show users

The following is a typical message:

User Level Last Login

--------- ----------

Alice	1	09:28:37 11/23/1998
Bill	1	14:06:25 11/17/1998
CarlSmith	2	11:17:45	11/22/1998
Dave46	3	12:14:33	11/20/1998

2.If user settings correct are correct, skip remaining steps.

NOTE: User names can be up to 10 characters long, and may use any combination of letters and numbers. Spaces and special characters are not allowed.

3.Add new user names with the following command:

add user <name>

Example: add user Alice

NOTE: All users have Level 1 access (highest) unless changed to a lower access level.

4.Set user access levels and passwords with the following command: set user <name> level <access>

Example: set user Alice level 2

The settings are as follows:

Setting Definition

1Set the user to access level 1 (highest).

2Set the user to access level 2.

3Set the user to access level 3 (lowest).

Access Navigator - Release 1.8 August 2003 8-9