Carrier Access user manual Attach Mounting Brackets to Access Navigator

Physical Installation

Attach Mounting Brackets to Access Navigator

Attach Mounting Brackets to Access Navigator

1.Open bag containing universal rack mounting kit and select the following items (see Figure 5-1):

•Mounting bracket (2 ea.), PN 0040303 (stamped on part)

Mounting

Brackets

Figure 5-1. Mounting Brackets

2.Position mounting brackets for required flush mount or 5-inch forward offset with respect to front rails of equipment rack (see A in Figure 5-2 on page 5-6).

3.Remove mounting screws (6-32 × 3/8 inch, 82º undercut, Phillips) from sides of Access Navigator where brackets will be attached.

4.Attach mounting brackets to sides of Access Navigator using mounting screws removed in previous step (see B in Figure 5-2).

Attach Access Navigator to Equipment Rack

CAUTION! ACCESS NAVIGATOR REQUIRES AT LEAST 4.37 INCHES (2.5 RACK UNITS) OF FREE AIR SPACE ABOVE AND BELOW CHASSIS FOR AIR CIRCULATION. INSUFFICIENT SPACING MAY CAUSE SERVICE INTERRUPTIONS, RESULTING FROM EQUIPMENT OVERHEATING AND SHUTTING DOWN.

1.Position Access Navigator in equipment rack slot (refer to office records). Ensure that there is at least 4.37 inches (2.5 rack units) of free air space above and below chassis for cooling (see Figure 5-3 on page 5-6).

2.Secure mounting brackets to equipment rack using appropriate mounting screws (see C in Figure 5-2). Brackets accommodate 1.75 and 2.00 inch hole spacing.

Access Navigator - Release 1.8 August 2003 5-5