Carrier Access Access Navigator user manual Send Remote Sdsl Payload Loopup

CLI Language Reference

CLI Command List

								RS-232
CA FDL							TSI Equipment Loopup
Command
				Access Bank II
Access
	DS1	T1	Framer			Time Slot			Interface
Navigator
					Interchange

RS-232

Figure 18-14. Remote RS-232 TSI Equipment Loopup

Security: Level 2 (operator)

Syntax: send remote <n> rs232 tsi <equipmentnetwork> loopup

Field	Description
n	DS1 number, 1 to 32.
equipment	Loopup the equipment side
network	Loopup the network side

Example: send remote 9 rs232 tsi equipment loopup

Example: send remote 9 rs232 tsi network loopup

Message: Loop command sent to remote.

Send Remote SDSL Payload Loopup

NOTE: This command applies only to a remote Access Bank II connected to the Access Navigator by a DS1 using Carrier Access FDL management protocol. For normal operation, the loopback must be disabled by the send remote loopdown command.

NOTE: Only one port of the Access Bank II can be looped up at a time. If a loopup command is received for a second port, the first port will be looped down automatically before the second port is looped up.

NOTE: To check remote loopback status, use the read remote loopback command. See Read Remote Loopback on page 18-51.

Purpose: Sends an out-of-band(FDL) message to a remote Access Bank II over the Access Navigator DS1. It is used to verify SDSL signal processing.

18-84 August 2003 Access Navigator - Release 1.8