Carrier Access Access Navigator Show Remote Connections, Syntax show remote n connections

	CLI Language Reference
	CLI Command List
Item	Description
Line Build Out	DSX-1 equalization (ft.), CSU attenuation (dB)
PRM	Performance messages: AT&T 54016, ANSI T1.1403
V.35 Port:
CTS	Always High, Always Low, Follow CD, Follow RTS
Rx Timing	Internal, External
Clock Inversion	None, Rx, Tx, Rx and Tx
Data Inversion	None, Invert
Speed	Data speed (Kbps): Nx56 or Nx64, where N is number of DS0s
	assigned
DSU	V.54 Data Service Unit (DSU) loopcode detection: On, Off
RS232 Port:
Baud Rate	1200, 2400, 4800, 9600, 19200, 38400, 57600
Data Bits	7, 8
Parity	None, Odd, Even
Stop Bits	1, 2

Show Remote Connections

Purpose: Displays crossconnections between interfaces inside the remote Access Bank II, including the T1 connection to the Access Navigator DS1.

NOTE: The show remote commands display the settings stored in the Access Navigator’s data base, while the read remote commands show the actual settings of the remote device. Both commands should display the same settings when remote configuration is enabled so the Access Navigator can provision the remote Access Bank II. Set Remote Config on page 18-119

Security: Level 3 (monitor)

Syntax: show remote <n> connections

Field

n

Description

DS1 number, 1 to 32.

Example: show remote 9 connections

This command produces a message similar to the following. The message shows static connections between each span and channel as a table, where the span is the interface and the channel is the DS0.

Access Navigator - Release 1.8 August 2003 18-151