Carrier Access Access Navigator user manual Snmp Requirements, Table C-3 Snmp Configuration Items

SNMP Interface

SNMP Requirements

SNMP Requirements

CLI commands must be used to configure the Access Navigator for SNMP operation. In particular, the operator must set up the Ethernet port, SNMP community strings, and NMS IP addresses. (See CLI Language Reference on page 18-1.) SNMP configuration includes the following items.

NOTE: To provide secure access, community strings are required for SNMP management, but can not be changed or displayed using SNMP set and get commands. Access attempts using invalid community names will be trapped and reported to the NMS.

Table C-3 SNMP Configuration Items

Commands	Descriptions
set ethernet ip address	Ethernet IP address and mask
set ip gateway	Gateway IP address
set snmp contact	System contact *
set snmp location	System location *
set snmp getcom	Get community
set snmp setcom	Set community
set snmp trapcom	Trap community
set snmp nms	NMS IP address (up to 3) †

*Contact and location can be changed through objects in the standard SNMP System Group.

† NMS IP addresses can be changed through objects in the Carrier Access Enterprise MIB.

C-8 August 2003 Access Navigator - Release 1.8