Carrier Access Access Navigator user manual Table C-4 Standard Snmp Trap Reports

SNMP Interface

SNMP Trap Reports

SNMP Trap Reports

The Access Navigator can send the following SNMP trap reports to up to three Network Management Systems (NMSs). NMS IP addresses can be set by CLI commands and through the SNMP interface. The trap-community strings can only be set using CLI commands (see SNMP Configuration Items on page C-8).

Table C-4 Standard SNMP Trap Reports

Trap	Description	Test Method
authenticationFailure	Occurs when a bad community string is	Attempt a Get or Set using an
	used.	invalid community string.
linkDown	Sent when a DS1 changes from an up (in	Disconnect an in-service DS1.
	service) state to a down (out of service)
	state. It is not sent when a DS1 is set
	“down” by a manual command.
	Also sent when a DS1 is set up manually,
	if it is in an out-of-service state.
linkUp	Sent when a DS1 changes from a down	Connect a DS1 and put it into
	(out of service) state to an up (in service)	service.
	state. It is not sent when a DS1 is set “up”
	by a manual command.
coldStart	Sent whenever the SNMP agent is	Cycle the power off and on.
	restarted as a result of a software reset or
	unit power-up.

Table C-5 Enterprise SNMP Trap Reports

Trap	Description	Test Method
anSwitchControllerTrap	Sent when switching redundant Controller	Issue the "switch controller"
	cards.	command.
anRemoteLinkUpTrap	Sent when a remote link-up is detected.	Connect an Access Bank II.
	The trap message will include the AB2
	Index and ID.
anRemoteLinkDownTrap	Sent when a remote link down is detected.	Disconnect an Access Bank
	The trap message will include the AB2	II.
	Index and ID.
anRemoteAlarmTrap	Sent when an alarm condition is detected	Cause alarms on connected
	or has cleared on a device attached to a	and in-service Access Bank or
	drop DS1.	Adit. Example: Disconnect a
		DS1 on an Adit that is not
		carrying the FDL.

Access Navigator - Release 1.8 August 2003 C-9