Carrier Access Access Navigator user manual Provision DS0 Crossconnects if required

Provision Remote Adit 600 via FDL

Provision DS0 Crossconnects (if required)

Provision DS0 Crossconnects (if required)

NOTE: Static DCS voice and data crossconnects, as well as ISDN BRI D (signaling) channels, must be provisioned in the Access Navigator. Crossconnects are not required for GR-303 voice and ISDN BRI B (bearer) channels because they are dynamically assigned by the switch.

1.Show current crossconnect settings with the following command: show connect <n>

Example: show connect 10

The show command will display the current settings for the specified DS1. For example, the message for DS1 number 11 would look similar to the following:

Connections for DS1 #10 (CA DS1# 10):

From To Type Interface [--> Port]

--------- ----- --------------------

10:01 ..... GR303 10:02 ..... GR303 10:03 ..... GR303 10:04 ..... GR303 10:05 ..... GR303 10:06 ..... GR303 10:07 ..... GR303 10:08 ..... GR303 10:09 ..... GR303 10:10 ..... GR303 10:11 ..... GR303 10:12 ..... GR303 10:13 .....

10:14 .....

10:15 .....

10:16 .....

10:17 17:12 DATA AcmeInternet --> V.35 10:18 17:13 DATA AcmeInternet --> V.35 10:19 17:14 DATA AcmeInternet --> V.35 10:20 17:15 DATA AcmeInternet --> V.35 10:21 17:16 DATA AcmeInternet --> V.35 10:22 17:17 DATA AcmeInternet --> V.35 10:23 17:18 DATA AcmeInternet --> V.35 10:24 17:19 DATA AcmeInternet --> V.35

2.If DS0 crossconnect settings are correct, skip remaining steps.

Access Navigator - Release 1.8 August 2003 12-15