Carrier Access Access Navigator user manual Indicator Descriptions, State Description, Green, Off

Diagnostics & Troubleshooting

Indicator Descriptions

Indicator Descriptions

Each Controller card provides the following indicators (see Table 15-1). Only the active Controller card will show alarm and status information. The LED on the active Controller will light green. On the standby Controller, only the Power status indicator will light. The Power LED will light on the active Controller.

NOTE: Note: Normal LED states are shown in Boldface type.

	Table 15-1. Indicator Descriptions
LED	State	Description
Power	Off	-48V power failure.
(Two LEDs, one for	Red	Internal power supply failure.
each Controller card)	Yellow	Card is booting up.
	Green	Normal operation.
Active (Controller)	Off	Controller card is standby.
	Green	Controller card is active.
	Yellow	Insufficient memory. SIMM (memory
		module) is required.
Critical Alarm	Off	No critical alarms present.
	Red	Critical alarm exists.
Major Alarm	Off	No major alarms present.
	Red	Major alarm exists.
Minor Alarm	Off	No minor alarms present.
	Yellow	Minor alarm exists.
ACO (alarm cut-off)	Off	Alarm(s) active.
	Yellow	Alarm(s) suppressed.
DS1 Status	Off	Off-line.
	Red	Loss of signal (LOS).
(Each Quad T1	Red Flashing Slow	Out of frame or AIS.
Framer card has four	Red Flashing Fast	Self-test failure.
LEDs)	Yellow	Line code violation (LCV).
	Yellow Flashing	Yellow alarm.
	Green	Normal operation.
	Green Flashing	Loopback test in progress.
Ethernet	Off	No link or connection.
(on rear panel)	Green	Normal operation.

15-10 August 2003 Access Navigator - Release 1.8