Carrier Access user manual Access Navigator Release August 13-23

Provision Remote Adit 600 via IP DS0

Provision Remote Adit 600

Provision Remote Adit 600

NOTE: Remote provisioning requires that the Adit 600 be pre-configured for IP DS0 management. The essential settings are listed in the Remote Adit IP DS0 Provisioning Quick Guide on page 13-7.

After configuring the Adit 600 for IP DS0 management, the remote terminal can be accessed through the Access Navigator as described in the following steps.

Carrier Access IP DS0 management also allows remote provisioning via Telnet and Carrier Access Valet™ and NetworkValet™ EMS software by using the IP address of the remote Adit 600.

1.Start remote management session with Adit 600 terminal, where <n> is the number of the Access Navigator drop DS1 going to the terminal.

logon remote <n>

Example: logon remote 10

2.When Adit 600 prompt appears, provision terminal using Adit 600 CLI commands (refer to Adit 600 User Manual.

3.When finished provisioning Adit 600 terminal, enter Ctrl+C to cancel the connection to the remote terminal. The Access Navigator prompt will then appear.

4.Exit management session when finished.

exit

Test DS1 and DS0 Circuits

NOTE: The Adit 600 also supports remote testing of its network and subscriber interfaces. See Adit 600 TDM User Manual.

NOTE: The Access Navigator supports the following T1.403 loop tests:

•Responds to ESF bit patterned loop requests (when loopdetect is on)

•Generates ESF bit patterned loop requests

•Generates SF CSU inband loopcodes

NOTE: The Access Navigator provides line and payload loopback commands for troubleshooting line problems. See Diagnostics & Troubleshooting on page 15-1.

1.Follow standard practices to test subscriber drop DS1 circuits.

2.Follow standard practices to test DS0 connections, analog channels, and remote interfaces.

Access Navigator - Release 1.8 August 2003 13-23