Carrier Access Access Navigator user manual Set Remote Config, Syntax set ip gateway address

CLI Language Reference

CLI Command List

Syntax: set ip gateway <address>

Field

address

Description

Gateway addresses have the format xxx.xxx.xxx.xxx, where each xxx is a decimal number between 0 and 255. If a gateway address is not used, you must enter none for the gateway address.

Example: set ip gateway 192.168.0.250

Example: set ip gateway none

Set Remote Config

Purpose: Enables and disables the downloading of configuration data to the remote terminal. The default setting is “on”, which enables the Access Navigator to automatically download configuration settings to the remote Access Bank II over the Carrier Access FDL management channel. This setting allows configuration changes to be sent immediately and provides flow-through provisioning when a remote Access Bank II is installed and powered up. When turned off, the Access Navigator will not download any configuration data.

NOTE: To speed up the provisioning of remote services, temporarily turn off remote configuration downloading to the Access Bank II. When finished, turn remote configuration on again, and the Access Navigator will download all changes at once. Downloading to each Access Bank II can take up to one minute. The status remote command will report “FDL tx in progress” during transmission and “FDL in service as CA FDL” when transmission is complete.

NOTE: Use the show remote command to display current settings in the Access Navigator data base.

NOTE: The set remote config command only affects your ability to write configuration settings to the remote Access Bank II data base. You can always use the read remote command to display the actual remote configuration settings whenever the Access Bank II is connected to the Access Navigator via the DS1 link and Carrier Access FDL management is selected. (See Provision Remote Access Bank II on page 11-1.)

Security: Level 2 (operator)

Access Navigator - Release 1.8 August 2003 18-119