Carrier Access Access Navigator user manual Status eoc, Show eoc

Alarm Clearing

Clear Alarms – FDL

Table 14-3 CLI Minor Alarm Message and Trouble Clearing Procedure

Event Message	Description	Trouble Clearing Procedure
EOC Primary/Secondary	EOC LAPD data link	Check status of DS1 assigned for
Link Down	communication not established	EOC with the following
	with the switch. Access Navigator	command:
	periodically retries to establish	status eoc
	LAPD data link with the switch.	Check EOC provisioning with the
	Ensure DS1 assigned to EOC is
	healthy.	following command:
	Note: This alarm will also occur if	show eoc
	TMC or EOC is set to none.	Use following command to change
		setting:
		set eoc <primary/secondary> ds1
		<n>
Manually set minor	Allows user to set and clear	Use following command to clear
alarm	critical alarm state. LED, relay,	alarm:
	alarm, and event logs follow	set alarms minor off
	setting.
On Board Power Supply	DC power supply on the controller	Reporting controller card (A or B)
A/B Failure	(A or B) caused a failure.	must be replaced.
Remote Device #n: T1	Remote device on DS1 #n	Clear trouble at remote device.
#x Loss of Carrier	reported loss of carrier on T1 #x.
Remote Device #n: T1	Remote device on DS1 #n	Clear trouble at remote device.
#x Loss of Synch	reported loss of synchronization
	on T1 #x.
Remote Device #n: T1	Remote device on DS1 #n	Clear trouble at remote device.
#x rx AIS	received Blue alarm (AIS) on T1
	#x.
Remote Device #n: T1	Remote device on DS1 #n	Clear trouble at remote device.
#x rx Yellow alarm	received Yellow alarm (RAI) on
	T1 #x.
Remote Device #n: V.35	Remote device on DS1 #n	Clear trouble at remote device.
loss of RTS	reported loss of RTS on V.35
	interface.

14-6 August 2003 Access Navigator - Release 1.8