Carrier Access Access Navigator Logon Remote, Syntax logon remote n, Example logon remote

CLI Language Reference

CLI Command List

Item	Description
Switch TermID:DS0	Switch terminal identifier, 1 to 28, and DS0 channel, 1 to 24.
	(TermID is not same as DS1 number.)
Drop DS1:DS0	Drop DS1 number, 1 to 32, and DS0 channel, 1 to 24.
CRV	Call Reference Value, 1 to 768
TMC Event	Message describing the event.
Cause	Numeric value assigned by switch to identify error type.

Logon Remote

Purpose: Starts a remote CLI management session with a Adit 600 TDM terminal connected to a DS1 drop. During an RS-232 or Telnet CLI management session, the user enters the logon remote command at the Access Navigator prompt. The remote terminal will then respond with a Adit 600 prompt for entering Adit 600 CLI commands. For descriptions of Adit 600 CLI commands, refer to the Adit 600 TDM User Manual.

NOTE: To exit from a remote management session, see Exit Remote

Session (Ctrl+C) on page 18-34.

Security: Level 2 (operator)

Syntax: logon remote <n>

Field	Description
n	DS1 number, 1 to 32.

Example: logon remote 12

The following example is typical response to the logon remote command:

Access Navigator> logon remote 3

Remote CLI session attached on ds1 3. (use <ctrl-c> to end remote CLI session.)

-----------------------------------------------------------

CLI session with remote goes here.

Session ends when user presses <ctrl-c>.

Terminating remote 3 CLI session...

-----------------------------------------------------------

Remote CLI session on ds1 3 terminated. Access Navigator>

18-44 August 2003 Access Navigator - Release 1.8