Carrier Access Access Navigator user manual Managing Users, Who Am, Show Users, Syntax show users

CLI Language Reference

Managing Users

Managing Users

CLI provides the manager with commands to show current users, add and delete users, and set access levels and passwords.

￿Who Am I ... 18-15

￿Show Users ... 18-15

￿Add User ... 18-16

￿Set User Access Level ... 18-16

￿Set User Password ... 18-17

￿Delete User Password ... 18-17

￿Delete User ... 18-17

Who Am I

The whoami command shows the name and access level of the user who is logged into the Access Navigator from the current management terminal. It produces a message similar to that shown below.

Syntax: whoami

Message: Logged in as user 'alice' (level 1)

Show Users

NOTE: Normally a user logs in once to start a management session, then logs off when done (exit command). The system allows the same user name to be “logged in” more than once. The total number of simultaneous sessions by all users can not exceed 3, comprising a maximum of 1 RS-232 session and 2 Telnet sessions.

Show current user settings and status with the following command.

Syntax: show users

The following is a typical message showing four users. Alice and Bill have level 1 (manager) access. Carl Smith has level 2 (operator) access. And Dave46 has level 3 (monitor) access. The message also gives the current login status and the time and date that each user last logged into the system.

Message:

User Level Logged in Last Login

--------- --------- ----------

alice	1	1	09:28:37 11/23/1998
bill	1	2	14:06:25 11/17/1998
carlsmith	2	0	11:17:45	11/22/1998
dave46	3	0	12:14:33	11/20/1998

Access Navigator - Release 1.8 August 2003 18-15