Carrier Access Access Navigator user manual Send Remote T1 Payload Loopup

CLI Language Reference

CLI Command List

When the operator enters a send remote command, the Access Navigator transmits a message over the Carrier Access FDL channel of the drop DS1. The Access Navigator’s drop DS1 is the Access Bank’s T1 connection.

The send remote <n> sdsl payload loopup command should cause the remote Access Bank II to perform a payload loopback on the SDSL data from both network and equipment sides. On the network side, this takes the received SDSL DS0s from the T1, loops it in the SDSL interface, and sends them back through the Time Slot Interchange (TSI) to the T1 output (see Figure 18-15). On the equipment side, this takes the received data from the SDSL equipment, loops it in the SDSL interface, and sends it back to the SDSL output. To loopdown the interface, use the send remote loopdown command.

								SDSL
CA FDL							Payload Loopup
Command
						Access Bank II
Access					Time Slot
	DS1	T1	Framer						Interface
Navigator
				Interchange

SDSL

Figure 18-15. Remote SDSL Payload Loopup

Security: Level 2 (operator)

Syntax: send remote <n> sdsl payload loopup

Field

n

Description

DS1 number, 1 to 32

Example: send remote 9 sdsl payload loopup

Message: Loop command sent to remote.

Send Remote T1 Payload Loopup

NOTE: This command applies only to a remote Access Bank II connected to the Access Navigator by a DS1 using Carrier Access FDL management protocol. For normal operation, the loopback must be disabled by the send remote loopdown command.

NOTE: Only one port of the Access Bank II can be looped up at a time. If a loopup command is received for a second port, the first port will be looped down automatically before the second port is looped up.

Access Navigator - Release 1.8 August 2003 18-85