Carrier Access Access Navigator user manual Set ds0 nch type voicedatagr303

Provision Remote Access Bank II

Provision DS0s

Type:GR303

Signaling: LOOP START

Up/Down:DOWN

Settings for DS1 13, Channel 2:

Type:GR303

Signaling: LOOP START

Up/Down:DOWN

Settings for DS1 13, Channel 3:

Type:	VOICE
Signaling:	GROUND START
Up/Down:	DOWN

Settings for DS1 13, Channel 4:

Type:DATA

Up/Down:DOWN

2.If drop DS0 settings are correct, skip remaining steps.

NOTE: GR-303 and DS0 voice channels use robbed-bit signaling, while DS0 data is clear channel.

3.Set DS0 type to voice, data, or GR-303 with the following command:

set ds0 <n:ch> type <voicedatagr303>

Example:	set ds0 25:1-18 type voice
Example:	set ds0 25:19-24 type data

NOTE: The Access Bank II supports one or two analog cards (12 channels per card). The default analog setting provides automatic ground start/loop start detection and translation for each analog channel. If E&M signaling is required, the DIP switches on the analog card must be set for E&M signaling, which applies to all channels on the card.

4.Set DS0 signaling (voice only) to Loop Start (ls), Ground Start (gs), or E&M (em) signaling with the following command:

set ds0 <n:ch> signal <lsgsem>

Example: set ds0 25:1-18 signal gs

5.Set DS0s to in-service (up) status with the following command: set ds0 <n:ch> up

Example: set ds0 11:1-16 up

11-18 August 2003 Access Navigator - Release 1.8