Carrier Access Access Navigator Clear Blocked Call Count, Clear Peak Call Count, Set CRV Idle

Diagnostics & Troubleshooting

Clear Blocked Call Count

Item	Description
Peak Calls	Maximum number of calls at one time. (To clear, see “Clear
	Peak Call Count” on page 28.)
Switch Ports	Number of DS0 ports connected to the switch (excludes EOC
	and TMC DS0s).
Percent Used	Percentage of switch ports in use, rounded to nearest whole
	number.

Clear Blocked Call Count

Sets the blocked call count to zero (see Status TMC on page 15-25).

Syntax: clear blocked call count

Clear Peak Call Count

Sets the peak call count to zero (see Status TMC on page 15-25).

Syntax: clear peak call count

Clear Permanent Call Count

Sets the permanent call count to zero (see Status TMC on page 15-25). After clearing the count, the Access Navigator will recalculate the current number of permanent calls.

Syntax: clear permanent call count

Set CRV Idle

Clears a permanent off-hook call state (see Status TMC on page 15-25) by setting it to the normal idle state. After clearing the count, the Access Navigator will recalculate the current number of permanent calls. A call can be active, idle, or permanent. You can check the current call state with the status crv command. An active call can not be set to idle.

Syntax: set crv <value> idle

Field

value

Description

Call Reference Value, 1 to 768, or a range of values such as 5-8. Maximum range is 24 CRVs.

15-28 August 2003 Access Navigator - Release 1.8