Carrier Access Access Navigator user manual Provision Groom DS1s to Adit Router

Provision Remote Adit 600 via IP DS0

Provision Groom DS1s to Adit Router

Provision Groom DS1s to Adit Router

NOTE: For IP DS0 management, it is recommended that DS1 #32 be connected to the colocated router.

1.Show groom DS1 settings with the following command: show ds1 <n>

Example: show ds1 32

The show command will produce a message showing the DS1 settings. For example, the message for DS1 number 1 might look similar to the following:

Settings for DS1 32:	CA DS1# 32
Circuit ID:
Up/Down:	UP
Framing:	ESF
Line Coding:	B8ZS
Type:	GROOM
Clock Source:	NORMAL
Line Build Out:	DSX-1 EQUALIZATION FOR 0-133 ft.
Loop Code Detection:	OFF
Loop Back:	OFF	(for switch DS1s only)
Line Termination ID:	0
Remote Device MGMT:	None
FDL Type:	None
Send Code:	OFF	15 min.	1 hour	1 day
Performance Thresholds:
unavailable seconds:	--------		--------	--------
		0	0	0
severely errored seconds:		0	0	0
errored seconds:		0	0	0
sev. errored frame seconds:		0	0	0
degraded minutes:		0	0	0
linecode violations:		0	0	0

NOTE: In the above message, Loop Back is a test function that is turned off during normal service. Line Termination IDs are used only for GR-303 switch DS1s. FDL Status does not appear if FDL Type is none.

P-Phone settings only appear in the Access Navigator / GR-303 Host with P-Phone option, when the Remote Management type is CA IP with P-Phone enabled and the remote device is an Adit 600. (If P-Phone isn’t enabled, the setting will list it as disabled.)

2. If groom DS1 settings are correct, skip remaining steps.

13-12 August 2003 Access Navigator - Release 1.8