Carrier Access Access Navigator user manual Set Snmp Properties, DNVRCO1A201

Provision Access Navigator

Set SNMP Properties

Set SNMP Properties

NOTE: Settings are text strings and may use any combination of letters and numbers. Settings must be enclosed in quote marks. The System Name, Location, and Contact strings may contain up to 255 characters. Community strings may contain up to 32 characters.

1.Show current SNMP settings with the following command: show snmp

The following is a typical message:

System Name:	Acme Corp AN#2
System Location:	DNVRCO1A201
System Contact:	Site Manager
GET Community:	Public
SET Community:	Public
TRAP Community:	Public
NMS #1:	192.168.0.65
NMS #2:
NMS #3:

2.If SNMP settings are correct, skip remaining steps.

3.Set SNMP System Name or Identification code with the following command: set snmp name <"setting">

Example: set snmp name "Acme Corp AN#2"

NOTE: Telcordia (Bellcore) Common Language Location Identifier (CLLI) codes are text strings with up to 11 characters.

4.Set SNMP System Location or CLLI code with the following command: set snmp location <"setting">

Example: set snmp location "DNVRCO1A201"

Example: set snmp location "Acme Corp AN#2"

5.Set SNMP System Contact with the following command: set snmp contact <"setting">

Example: set snmp contact "Site Manager"

6.Set SNMP Get-Community string with the following command: set snmp getcom <"setting">

Example: set snmp getcom "Public"

7.Set SNMP Set-Community string with the following command: set snmp setcom <"setting">

Access Navigator - Release 1.8 August 2003 8-11