Carrier Access Access Navigator user manual Send Remote RS232 TSI Network Loopup

Diagnostics & Troubleshooting

Send Remote RS232 TSI Network Loopup

Send Remote RS232 TSI Network Loopup

This command makes the remote Access Bank II perform a network loopback on the RS-232 data. This takes the received RS-232 DS0 from the network T1, loops it in the Time Slot Interchange (TSI), and sends it back to the T1 output. See Figure 15-13.

Syntax: send remote 9 rs232 tsi network loopup

								RS-232
CA FDL							TSI Network Loopup
Command
				Access Bank II
Access						Time Slot			Interface
	DS1	T1	Framer
Navigator
					Interchange

Figure 15-13. Remote RS-232 TSI Network Loopup

Send Remote SDSL Payload Loopup

RS-232

This command makes the remote Access Bank II/SDSL perform a payload loopback on the SDSL data from both network and equipment sides. On the network side, this takes the received SDSL DS0s from the T1, loops it in the SDSL interface, and sends them back through the Time Slot Interchange (TSI) to the T1 output. On the equipment side, this takes the received data from the SDSL equipment, loops it in the SDSL interface, and sends it back to the SDSL output. See Figure 15-14.

Syntax: send remote <n> sdsl payload loopup

								SDSL
CA FDL							Payload Loopup
Command
						Access Bank II
Access					Time Slot
	DS1	T1	Framer						Interface
Navigator
				Interchange

SDSL

Figure 15-14. Remote SDSL Payload Loopup

15-38 August 2003 Access Navigator - Release 1.8