Carrier Access Access Navigator user manual Install Simm, Location of Controller Cards

Maintenance Procedures

Install SIMM on Controller Card

Install SIMM

CAUTION! DO NOT REMOVE THE ACTIVE CONTROLLER CARD.

1. Locate standby Controller card slot (see Figure 16-2).

Controller A Controller B

Figure 16-15. Location of Controller Cards

NOTE: The example in Figure 16-16shows installation and removal of Controller B.

2.Push both card ejector latches on standby Controller toward outside of card until card connector releases with backplane connector (see A in Figure 16-16).

3.Slide standby Controller partially out of card slot to expose SIMM socket (see B in Figure 16-16).

4.Remove SIMM from anti-static bag.

5.Hold SIMM at about a 45 degree angle with notch positioned at front of socket (see C in Figure 16-16)and insert connector edge of SIMM into socket.

6.Push SIMM down toward circuit board until it snaps into socket clamps (see D in Figure 16-16).

7.Carefully slide upgraded Controller back into card slot.

8.Press card ejector latches in toward center of card until card connector mates with backplane connector (see E in Figure 16-16).

Access Navigator - Release 1.8 August 2003 16-33