Carrier Access Access Navigator user manual Set DS1 identification

Provision Remote Adit 600 via IP DS0

Provision Drop DS1s to Remote Adit

10.Set drop DS1 line buildout (lbo) to required DSX-1 equalization or CSU attenuation set ds1 <n> lbo <setting>

Example: set ds1 1 lbo 1

The setting is a number from 1 to 9, and is defined as follows:

Setting Definition

1Set DSX-1 equalization for 0-133 ft.

2Set DSX-1 equalization for 133-266 ft.

3Set DSX-1 equalization for 266-399 ft.

4Set DSX-1 equalization for 399-533 ft.

5Set DSX-1 equalization for 533-666 ft.

6Set CSU attenuation for LBO of 0dB.

7Set CSU attentation for LBO of -7.5dB.

8Set CSU attenuation for LBO of -15dB.

9Set CSU attenuation for LBO of -22.5dB.

NOTE: When loop code detection is turned on, the Access Navigator will respond to T1.403 ESF bit patterned loop requests. Loop detection is normally turned off for DS1 drops.

11.Set drop DS1 loop request code detection off with the following command: set ds1 <n> loopdetect off

Example: set ds1 1 loopdetect off

12. Set DS1 identification

set ds1 <n> id <"name">

Example: set ds1 25 id "DS1#10"

13.Set DS1 in service set ds1 <n> up

Example: set ds1 1 up

Access Navigator - Release 1.8 August 2003 13-17