Carrier Access Access Navigator user manual Set ds1 n down set ds0 nch down

Provision GR-303 Service

Set Unused Circuits Out of Service

NOTE: Commands containing ds0 <n:ch> require the operator to enter both the DS1 and DS0 channel number or channel range. The DS1 and DS0 numbers are entered with a colon separating the numbers. For example, the channel list for DS1 #4 and DS0 channel #8 would be entered as ds0 4:8. The channel list may also contain a range of DS0 channels. For example, DS1 #6 and DS0 channels #1 through #12 would be entered as ds0 6:1-12. A colon follows the DS1 number, and the beginning and ending DS0 channels are separated by a hyphen.

6.Display current DS0 status with the following command, where <n:ch> is the DS0 or range of DS0s in the DS1 to be turned up:

status ds0 <n:ch>

Example: status ds0 1:1-4

The status command will display the status for each DS0 specified. For example, the message for DS1 #1, DS0 channels 1 to 4, and DS1 #32, DS0 channels 1 to 4, would look similar to the following:

Interface		Status
---------		------
DS1 1	Channel 1	In Service
DS1 1	Channel 2	In Service
DS1 1	Channel 3	In Service
DS1 1	Channel 4	Out of Service

DS1 32		Channel 1		Card Not Installed
DS1 32		Channel 2		Card Not Installed
DS1	32	Channel	3	Card	Not	Installed
DS1	32	Channel	4	Card	Not	Installed

7.Verify status of DS0 circuits on DS1 lines to be turned up by comparing DS0 status with office records. If there is a discrepancy, follow standard practices to resolve problem.

Set Unused Circuits Out of Service

NOTE: The factory default sets all DS1s and DS0s in-service (up). To prevent inadvertent service disruptions, it is good practice to set circuits out of service (down) when not in use or not provisioned in the switch. Set the type of unused DS0 channels to match the DS0 type configured on the device at the other end of the DS1. If the DS1 is not terminated, set the type to data.

Set unused circuits out of service with the following commands.

set ds1 <n> down set ds0 <n:ch> down

set ds0 <n:ch> type <voicedata>

Access Navigator - Release 1.8 August 2003 10-13